Articlo
Check my manuscript free

Taylor & Francis

Prepare your manuscript for Archives of Phytopathology and Plant Protection.

Review the checklist, choose your article type, and turn your draft into a cleaner submission package.

Checked 2026-08-01
Check readiness freePrepare this manuscript

Article types

Review
Original Article
Review Article
Methods Article
Protocol
Editorial
Clinical Trial
Systematic Review
Letter
Lectio

Readiness requirements

Review the key details below, or download the complete checklist with every stored source-backed requirement.

Abstract length

  • Provide an author-written abstract of no more than 150 words.
  • The abstract should not exceed 150 words.
Show 3 more
  • The abstract structure should be as follows: Introduction, Methods, Results, Discussion.
  • Similar to research papers, Technical Support and Comment should be set out with an objectives, rationale, materials and methods, results, table or figure, and impact of the study stated after the abstract, in one section, with a proper analysis of data.
  • There are no strict formatting requirements, but all manuscripts must contain the essential elements needed to evaluate a manuscript: abstract, author affiliation, figures, tables, funder information, and references.

Keywords

  • Provide 3-6 keywords chosen by the author.
  • Should contain between 3 and 6 keywords.

Reference style

  • Articlo formats your supplied references to the journal's stored style and checks that citations match the reference list; source validity is not verified.
  • For Comment and Technical Support, authors may present their preliminary important research findings over a maximum of 3 pages not exceeding 3000 words, with a maximum of 10 references and a table and/or figure.
Show 4 more
  • All bibliographic entries must contain a corresponding in-text citation.
  • Where applicable, this should include the hyperlink, DOI or other persistent identifier associated with the data set(s).
  • Readers should be able to interpret the table without reference to the text.
  • A declaration must be included within the submission stating: Confirmation the authors take full responsibility for the integrity of the whole content, including accuracy of references.

Figure and table rules

  • Keep every figure and table numbered, captioned, and cited in the manuscript.
  • Figures should be high quality (1200 dpi for line art, 600 dpi for grayscale and 300 dpi for colour, at the correct size).
Show 3 more
  • Figures should be of sufficient resolution to enable refereeing.
  • Tables should present new information rather than duplicating what is in the text.
  • Figures should be supplied in one of our preferred file formats: PS, JPEG, TIFF, or Microsoft Word (DOC or DOCX) files are acceptable for figures that have been drawn in Word.

Funding statement

  • You should declare only the acquired funds and grants that are directly relevant to the work reported in your article; for example, This work was supported by the [Funding Agency #1] under Grant [number xxxx]; [Funding Agency #2] under Grant [number xxxx]; and [Funding Agency #3] under Grant [number xxxx].

Competing interests

  • Include or confirm the competing interests required by the journal. Articlo checks this item and flags anything that still needs author input.

Data availability statement

  • Include or confirm the data availability statement required by the journal. Articlo checks this item and flags anything that still needs author input.

Ethics statement

  • Include or confirm the ethics statement required by the journal. Articlo checks this item and flags anything that still needs author input.

Blinded manuscript

  • Remove author names, affiliations, acknowledgements, and other direct identifiers from the blinded manuscript file.
  • NOTE: the anonymous version of the MS should not have the following info or it will be returned: - Acknowledgement.

Cover letter

  • Review / Review Article: Authors should seek permission from the Editor-In-Chief and discuss the content and subject prior submission of a review article.
  • Using Third-Party Material in your Paper You must obtain the necessary permission to reuse third-party material in your article.
Show 2 more
  • Review: The use of short extracts of text and some other types of material is usually permitted, on a limited basis, for the purposes of criticism and review without securing formal permission.
  • If you wish to include any material in your paper for which you do not hold copyright, and which is not covered by this informal agreement, you will need to obtain written permission from the copyright owner prior to submission.

Author contributions

  • Submitting authors should be prepared to submit CRediT roles for themselves and their co-authors (where applicable) as part of the submission process.

Title page and author information

  • All authors of a manuscript should include their full name and affiliation on the cover page of the manuscript.
  • One author will need to be identified as the corresponding author, with their email address normally displayed in the article PDF (depending on the journal) and the online article.

Article structure and word limits

  • Should be at between 2500 and 4000 words in length.
  • It should be a maximum width of 525 pixels.
Show 17 more
  • Review: These instructions will ensure we have everything required so your paper can move through peer review, production and publication smoothly.
  • Your research funder or your institution may require you to publish your article open access.
  • Use our APC finder to view the APC for this journal.
  • These should include adequate and appropriate validation to be considered.
  • Any datasets associated with the paper must publish all experimental controls and make full datasets available where possible.
  • If there are concerns about identifying factors in datasets, these should be discussed with the Editor-in-Chief prior to submission.
  • Please note, this is not required for submission but is encouraged.
  • Note that, regardless of the file format of original submission, an editable version of the article must be supplied at the revision stage.
  • Review: Two versions of the MS should be uploaded for peer review: - Manuscript - with author details.
  • Queries Should you have any queries, please visit our Author Services website or contact us here.
  • A declaration must be included within the submission stating: Originality and accuracy of content has been confirmed by the authors.
  • Authors must provide full methodological details and adhere to relevant reporting guidelines where applicable.
  • Authors must retain the original and revised versions which must be shared upon request.
  • The PLSP guidelines for authors must be followed at all times.
  • Please use SI units (non-italicized).
  • Please do not embed it in the manuscript file but save it as a separate file, labelled GraphicalAbstract1.
  • Image descriptions are typically used by systems such as pronouncing screen readers to make images accessible to people that cannot read or see the object due to a visual disability.

Reporting guidelines

  • Include or confirm the reporting guidelines required by the journal. Articlo checks this item and flags anything that still needs author input.

Artificial intelligence disclosure

  • Add or confirm the author-written Artificial intelligence statement; Articlo flags it if author input is still needed.
  • Please include a statement disclosing whether and how generative AI has been used in the research and manuscript preparation process.
Show 6 more
  • Use of AI tools as part of ethical research studies is permitted.
  • A declaration must be included within the submission stating: The name and version number of the AI tool used.
  • Systematic Review: Use of AI tools as part of ethically conducted literature reviews, systematic reviews, meta-analysis and bibliometrics studies is permitted.
  • Use of AI tool assisted plain language summaries (PLS) of authors own work is permitted.
  • Please read our guidance on using AI tools in your research and manuscript preparation to understand scenarios where their use may be permissible, and the required information that must be disclosed.
  • A declaration must be included within the submission stating: Confirmation the authors have checked terms of use for the specific AI tool used, and therefore confirm suitability for publication.

Manuscript structure

  • Review: The review must integrate and interpret the current information (last five years), summarize the results and propose new direction.
  • Authors must retain full records of the methods undertaken, including full descriptions and records of the prompts used, which must be shared with the journal upon request.

Article type and manuscript length

  • Preparing Your Paper Structure Your paper should be compiled in the following order: title page; abstract; keywords; main text introduction, materials and methods, results, discussion; acknowledgments; declaration of interest statement; references; appendices (as appropriate); table(s) with caption(s) (on individual pages); figures; figure captions (as a list).
  • Should be written with the following elements in the following order: title page; abstract; keywords; main text introduction, materials and methods, results, discussion; acknowledgments; declaration of interest statement; author contributions statement; references; appendices (as appropriate); table(s) with caption(s) (on individual pages); figures; figure captions (as a list).

Study reporting guidelines

  • Authors must provide full methodological details and adhere to relevant reporting guidelines where applicable (e.g. CONSORT-AI, STARD-AI, GAMER, TRIPOD-AI, etc).
Save journal and get updates Download complete checklist

What your package checks

Abstract: 150 words
Keywords: 3-6 keywords
Declarations: Acknowledgements, Artificial intelligence

Source transparency

This preparation guide uses published journal-specific author requirements. Journal instructions can change, so authors should complete a final review before submission.

Open official guideline source