Articlo
Check my manuscript free

Taylor & Francis

Prepare your manuscript for Journal of Asian Natural Products Research.

Review the checklist, choose your article type, and turn your draft into a cleaner submission package.

Checked 2026-08-01
Check readiness freePrepare this manuscript

Article types

Review
Original Article
Data Note
Registered Report
Research Article
Protocol
Lectio
Editorial
Clinical Trial
Systematic Review
Letter

Readiness requirements

Review the key details below, or download the complete checklist with every stored source-backed requirement.

Abstract length

  • Provide an author-written abstract of no more than 250 words.
  • Use a unstructured abstract.
Show 7 more
  • Should contain a structured abstract of 250 words.
  • Should contain an unstructured abstract of 250 words.
  • Should contain an unstructured abstract of 200 words.
  • Should be no more than 3500 for Stage 1 reports and no more than 5000 words for Stage 2, inclusive of the abstract, tables, references, figure captions, footnotes, and endnotes.
  • The abstract structure should be as follows: Introduction, Methods, Results, Discussion.
  • For papers containing multiple structures they should be referred to in the abstract.
  • There are no strict formatting requirements, but all manuscripts must contain the essential elements needed to evaluate a manuscript: abstract, author affiliation, figures, tables, funder information, and references.

Keywords

  • Provide 3-6 keywords chosen by the author.
  • Should contain between 3 and 6 keywords.
Show 1 more
  • Should contain no more than 6 keywords.

Reference style

  • Articlo formats your supplied references to the journal's stored style and checks that citations match the reference list; source validity is not verified.
  • A typical paper for this journal should be no more than 2500 words, inclusive of: References.
Show 5 more
  • For manuscripts submitted in LaTeX format a.bib reference file must be included.
  • All bibliographic entries must contain a corresponding in-text citation.
  • Where applicable, this should include the hyperlink, DOI or other persistent identifier associated with the data set(s).
  • Readers should be able to interpret the table without reference to the text.
  • A declaration must be included within the submission stating: Confirmation the authors take full responsibility for the integrity of the whole content, including accuracy of references.

Figure and table rules

  • Keep every figure and table numbered, captioned, and cited in the manuscript.
  • A typical paper for this journal should be no more than 2500 words, inclusive of: Tables.
Show 10 more
  • A typical paper for this journal should be no more than 2500 words, inclusive of: Figure or table captions.
  • Figures should be high quality (1200 dpi for line art, 600 dpi for grayscale and 300 dpi for colour, at the correct size).
  • Tables of ½F 0 ½ and F c should be submitted with the typescript for refereeing purposes.
  • Figures should be of sufficient resolution to enable refereeing.
  • Tables should present new information rather than duplicating what is in the text.
  • Figures must be clearly and sensibly labeled.
  • A figure of the supramolecular assembly is also required and may be submitted in color if necessary for clarification and understanding of the structure.
  • Tables of selected bond lengths and angles (with standard uncertainties) should include significant values only.
  • Figures should be supplied in one of our preferred file formats: PS, JPEG, TIFF, or Microsoft Word (DOC or DOCX) files are acceptable for figures that have been drawn in Word.
  • A figure containing the fully labeled asymmetric unit, as a thermal ellipsoid plot, must be submitted (as supplementary material, if it is not otherwise used in the manuscript).

Funding statement

  • You should declare only the acquired funds and grants that are directly relevant to the work reported in your article; for example, This work was supported by the [Funding Agency #1] under Grant [number xxxx]; [Funding Agency #2] under Grant [number xxxx]; and [Funding Agency #3] under Grant [number xxxx].

Competing interests

  • Include or confirm the competing interests required by the journal. Articlo checks this item and flags anything that still needs author input.

Data availability statement

  • Data Note: Add or confirm the author-written Data availability statement; Articlo flags it if author input is still needed.
  • Data Note: Further to the data sharing policy for the journal, Data Note submissions must include a Data Availability Statement and describe data available via a Repository.

Ethics statement

  • Include or confirm the ethics statement required by the journal. Articlo checks this item and flags anything that still needs author input.

Cover letter

  • Using Third-Party Material You must obtain the necessary permission to reuse third-party material in your article.
  • Review: The use of short extracts of text and some other types of material is usually permitted, on a limited basis, for the purposes of criticism and review without securing formal permission.
Show 1 more
  • If you wish to include any material in your paper for which you do not hold copyright, and which is not covered by this informal agreement, you will need to obtain written permission from the copyright owner prior to submission.

Author contributions

  • Submitting authors should be prepared to submit CRediT roles for themselves and their co-authors (where applicable) as part of the submission process.

Supplementary files

  • Lectio: Include every cited supplementary file and use matching labels in the manuscript.
  • Letter: Include every cited supplementary file and use matching labels in the manuscript.
Show 10 more
  • Review: Include every cited supplementary file and use matching labels in the manuscript.
  • Protocol: Include every cited supplementary file and use matching labels in the manuscript.
  • Data Note: Include every cited supplementary file and use matching labels in the manuscript.
  • Editorial: Include every cited supplementary file and use matching labels in the manuscript.
  • Clinical Trial: Include every cited supplementary file and use matching labels in the manuscript.
  • Original Article: Include every cited supplementary file and use matching labels in the manuscript.
  • Research Article: Include every cited supplementary file and use matching labels in the manuscript.
  • Registered Report: Include every cited supplementary file and use matching labels in the manuscript.
  • Embed or attach the author-supplied supplementary material so Articlo can extract and label it for the package.
  • Supplementary Material A fully completed CIF (Crystallographic Information File) should be deposited with the CCDC (send files as attachments to deposit@ccdc.cam.ac.uk) and the returned deposition number quoted in the experimental section of the manuscript.

Title page and author information

  • All authors of a manuscript should include their full name and affiliation on the cover page of the manuscript.
  • One author will need to be identified as the corresponding author, with their email address normally displayed in the article PDF (depending on the journal) and the online article.

Article structure and word limits

  • Should be no more than 3000 words.
  • It should be a maximum width of 525 pixels.
Show 20 more
  • CRYSTALLOGRAPHIC INSTRUCTIONS FOR AUTHORS The recommendations of the Commission on Crystallographic Data of the International Union of Crystallography should be followed in reporting analyses (see Acta Cryst., 1967, 22, 445--449).
  • Review: These instructions will ensure we have everything required so your paper can move through peer review, production and publication smoothly.
  • In each case, positive controls should be used and the dose/dependence should be shown.
  • Physical and spectral data must be reported on all new compounds and key intermediates.
  • Your research funder or your institution may require you to publish your article open access.
  • Use our APC finder to view the APC for this journal.
  • Note that, regardless of the file format of the original submission, an editable version of the article must be supplied at the revision stage.
  • You will also need to upload your LaTeX source files, which should be uploaded as a single zip file alongside your submission and marked as “LaTeX Source Files”.
  • Drawings of crystal or molecular structures should be made with the non-crystallographer in mind.
  • If the structure was refined anisotropically, the orientations and the magnitudes of vibrational ellipsoids should be displayed.
  • The following data should be reported in the manuscript: 1.
  • Any differences from expected values should be noted.
  • A declaration must be included within the submission stating: Originality and accuracy of content has been confirmed by the authors.
  • Authors must provide full methodological details and adhere to relevant reporting guidelines where applicable.
  • Authors must retain the original and revised versions which must be shared upon request.
  • The PLSP guidelines for authors must be followed at all times.
  • Data Note: Data Notes should only describe the data.
  • Please use SI units (non-italicized).
  • Please do not embed it in the manuscript file but save it as a separate file, labelled GraphicalAbstract1.
  • Image descriptions are typically used by systems such as pronouncing screen readers to make images accessible to people that cannot read or see the object due to a visual disability.

Reporting guidelines

  • Include or confirm the reporting guidelines required by the journal. Articlo checks this item and flags anything that still needs author input.

Preprints and prior publication

  • If you have shared an earlier version of your Author’s Original Manuscript on a preprint server, please be aware that anonymity cannot be guaranteed.

Artificial intelligence disclosure

  • Add or confirm the author-written Artificial intelligence statement; Articlo flags it if author input is still needed.
  • Please include a statement disclosing whether and how generative AI has been used in the research and manuscript preparation process.
Show 6 more
  • Use of AI tools as part of ethical research studies is permitted.
  • A declaration must be included within the submission stating: The name and version number of the AI tool used.
  • Systematic Review: Use of AI tools as part of ethically conducted literature reviews, systematic reviews, meta-analysis and bibliometrics studies is permitted.
  • Use of AI tool assisted plain language summaries (PLS) of authors own work is permitted.
  • Please read our guidance on using AI tools in your research and manuscript preparation to understand scenarios where their use may be permissible, and the required information that must be disclosed.
  • A declaration must be included within the submission stating: Confirmation the authors have checked terms of use for the specific AI tool used, and therefore confirm suitability for publication.

Statistical reporting

  • Pharmacological Investigations JANPR will only consider manuscripts in which conclusions are based on adequate statistics which account for the type of data distribution, on the number of experimental observations required for the application of the respective statistical method, and which incorporate the appropriate tests of significance.

Manuscript structure

  • A typical paper for this journal should be no more than 2500 words, inclusive of: Footnotes.
  • A typical paper for this journal should be no more than 2500 words, inclusive of: Endnotes.
Show 8 more
  • Data Note: Data Notes do not include any interpretation or conclusion of the data (see preparing your paper).
  • Results should be presented as succinctly as possible.
  • If the data were collected with counter techniques, a complete description of the type of instrument, type of scan, and method of handling background should be given.
  • Experimental Section Routine crystal structure determinations should be reported concisely.
  • When non-routine procedures have been employed a brief description of the methods used should be included.
  • A fully completed CIF (Crystallographic Information File) should be deposited with the CCDC (send files as attachments to deposit@ccdc.cam.ac.uk ) and the returned deposition number quoted in the experimental section of the manuscript.
  • Final R values (and whether quoted for all or observed data) Discussion Section A concise description of the molecular and supramolecular structures should be included for each structure determination presented.
  • Authors must retain full records of the methods undertaken, including full descriptions and records of the prompts used, which must be shared with the journal upon request.

Article type and manuscript length

  • Should be written with the following elements in the following order: title page; abstract; keywords; main text introduction, materials and methods, Data description, discussion; acknowledgements; declaration of interest statement; author contributions statement and ethics; data availability statement; references; appendices (as appropriate); table(s) with caption(s) (on individual pages); figures; figure captions (as a list).
  • Should be written with the following elements in the following order: title page; abstract; keywords; main text introduction, materials and methods, results, discussion; acknowledgments; data availability statement; declaration of interest statement; references; appendices (as appropriate); table(s) with caption(s) (on individual pages); figures; figure captions (as a list).
Show 1 more
  • Preparing Your Paper Structure Your paper should be compiled in the following order: title page; abstract; keywords; main text introduction, materials and methods, results, discussion; acknowledgments; declaration of interest statement; references; appendices (as appropriate); table(s) with caption(s) (on individual pages); figures; figure captions (as a list).

Blinded manuscript

  • The PDF should be uploaded as the “Manuscript - with author details”/“Manuscript - anonymous” file.

Study reporting guidelines

  • Authors must provide full methodological details and adhere to relevant reporting guidelines where applicable (e.g. CONSORT-AI, STARD-AI, GAMER, TRIPOD-AI, etc).
Save journal and get updates Download complete checklist

What your package checks

Abstract: 250 words
Paper: 2,500 words
Keywords: 3-6 keywords
Declarations: Artificial intelligence

Source transparency

This preparation guide uses published journal-specific author requirements. Journal instructions can change, so authors should complete a final review before submission.

Open official guideline source